All Categories
EN

Home >Products >Network /signal surge protect >POE Surge Protector >

POE SPD WPX-PTSA-8R4-48

POE SPD WPX-PTSA-8R4-48


Product introduction:802.3af and 802.3at Power over Ethernet, PoE compliant; multistage protection, low Residual voltage.

Product application:It is used for the surge protection of network servers, routers, network switches, HUB, computer networks,100M/1000M Ethernet,IP phones and other devices in the network information terminal line.

Phone number:+86-731-88650578

Contact E-mail:service@hnwpx.com


Specifications
Model NumberWPX-PTSA-8R4-48
Art No. 
Operating Temperature Range-40℃~80℃
Relative Humidity≤95%(25℃)
Atmospheric Pressure86~106 kPa
Working Voltage( Uo)48V
DC Max. continuous operating voltage(URCR)58V
Max Working Current IRL0.8A
POE power supply1,2-3,6 or 4,5-7,8 ;Total 75W
C2 Total nominal discharge current (8/20μs)(Itotal)10kA
C2 Nominal discharge current (8/20μs)per wire(In)2.5kA
Total nominal discharge current C2 -PE(Itotal)20kA
Nominal discharge current per wire C2-PE(In)2.5kA
Voltage protection level wire-wire (UP)≤40V
Voltage protection level wire-PE(UP)≤1000V
Voltage protection level wire-wire 1kV/μsC3(UP)≤20V
Voltage protection level wire-PE 1kV/μsC3(UP)≤600V
Response time(tA)≤1ns
Insertion loss(100MHz)≤1.0dB
transmission rate1000Mbps
Impedance in series≤0.5Ω
Protected pin1/2;3/6;4/5;7/8
Wiring methodsRJ45(shield)
Port numbersin-16×RJ45;out-16×RJ45
Housing materialSPCC
Degree of protectionIP20
Installation placeIndoor
Installation methods1U/19-inch rack
Diagram of dimensions

图片1

Description

The POE surge protector series is used to protect the interface circuit of high-speed Ethernet. It is connected to the input end of the protected device. When the transmission line is hit by lightning, the lightning current discharges to the ground through the lightning branch ,and clamps the lightning overvoltage within the appropriate range, thus ensuring the safety of the equipment.

INQUIRY

Worktime:8:00 ~ 17:00

ENQUIRE NOW

close
Enquire Now